Hands-on tutorial
Tutorials · PoE
How to Plan PoE for Smart Buildings: Lighting, Sensors and Building Devices
Use PoE to power LED lighting, occupancy sensors, displays and building controllers: power budgets, switch placement, cabling, security and coordination with electrical and BMS teams.
Before you start
- The list of building devices and their power
- Ceiling layouts and cable routes
- Requirements from the electrical and building management teams
Step by step
Count devices and power
List lights, sensors, displays and controllers with their maximum power. LED fixtures often need 802.3bt; sensors need very little.
Place switches close to loads
Smaller PoE switches in ceiling zones or floor cabinets shorten cable runs and reduce losses.
Use the right cable
Cat6A or Cat6 in bundles handles PoE heat better; respect bundle sizes from the cabling standard.
Plan for power loss
Decide which devices must stay on during outages (emergency lighting follows separate rules), and put those switches on UPS power.
Separate and secure
Put building devices on their own VLANs with access only to their controllers, and protect management interfaces.
Coordinate with other trades
Agree responsibilities for lighting design, controls programming and network configuration early in the project.
Pro tips
- Use PoE scheduling to turn off unused devices outside hours where safe.
- Monitor PoE consumption per port to spot faults.
- Keep spare budget for adding sensors later.
FAQ
Frequently asked questions
Can PoE replace mains wiring for lighting?
For many LED fittings, yes, where local regulations allow; emergency lighting has its own requirements.
What PoE standard do LED lights need?
Many need 802.3bt; check each fixture's datasheet.
Keep learning
Related guides
PoE vs PoE+ vs PoE++
Read more →Connect IoT devices safely
Read more →PoE for door access control
Read more →How to Use PoE Scheduling and Remote Power-Cycling
Save energy by switching PoE off outside business hours, and reboot a frozen camera or access point remotely.
Read more →How to Troubleshoot PoE Devices That Won't Power Up or Keep Rebooting
A systematic checklist for cameras and access points that stay dark, flicker or reboot at night.
Read more →How to Choose the Right PoE Standard (802.3af, 802.3at or 802.3bt) for Each Device
Match every IP camera, access point and phone to the right PoE class, check the switch port and the total budget, and avoid devices that reboot or never power up.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.