Hands-on tutorial

Tutorials · PoE

How to Choose the Right PoE Standard (802.3af, 802.3at or 802.3bt) for Each Device

Match every IP camera, access point and phone to the right PoE class, check the switch port and the total budget, and avoid devices that reboot or never power up.

Beginner9 min6 steps

Before you start

  • The datasheet of each powered device (look for 'power consumption' or 'PoE class')
  • The datasheet of the PoE switch: PoE standard per port and total PoE budget
  • A list of devices per switch

Step by step

  1. Read the device's maximum power

    Take the maximum, not the typical figure. Cameras draw most at night with infrared on, and outdoor cameras with heaters draw much more in winter. Wi-Fi 7 access points draw most with all radios busy.

  2. Map the power to a PoE standard

    802.3af (PoE) delivers up to 15.4 W at the switch port, about 12.95 W at the device. 802.3at (PoE+) delivers 30 W, about 25.5 W at the device. 802.3bt (PoE++) delivers 60 W (type 3) or 90 W (type 4) at the port. Pick the lowest standard that covers the device's maximum.

  3. Check each switch port

    A switch may offer PoE+ on every port but 802.3bt only on a few. Put high-power devices such as PTZ cameras with heaters or multi-radio access points on the bt-capable ports.

  4. Check the total budget

    Add the maximum power of every device on the switch and add 20–30% headroom. The total must stay below the switch's PoE budget, or the switch will refuse or drop power to some ports.

    show poe status
    show poe power-budget
    
  5. Check the cable

    Use Cat5e or better, at most 100 m. Long runs of thin or copper-clad aluminium cable lose power as heat and are the most common cause of devices that reboot under load.

  6. Verify under load

    Power everything on, switch camera infrared on (cover the lens or test at night), and read the per-port power on the switch. Each port should stay below its class limit.

Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.

Pro tips

  • Label high-power ports on the switch and in your documentation.
  • Leave a few spare PoE ports and budget for future cameras.
  • Use the PoE watchdog or scheduled reboot for cameras that occasionally freeze.