Hands-on tutorial
Tutorials · Fibre & GPON
How to Find Fibre Faults With a Visual Fault Locator and an OTDR
Locate breaks, tight bends, bad splices and dirty connectors on fibre links, from a simple red-light check to an OTDR trace that shows exactly where the loss is.
Before you start
- A visual fault locator (red laser pen)
- An optical power meter and light source
- An OTDR with launch fibre, for longer links
- The link documentation: length, splices, patch panels
Step by step
Start with the simple checks
Clean and inspect connectors, check that transmit and receive are not swapped, and read the optical levels on both transceivers.
show interfaces transceiver detailMeasure the loss
Use a light source at one end and a power meter at the other. Compare the loss with the expected budget: fibre length, connectors and splices.
Use a visual fault locator for short links
Shine the red light into the fibre. Breaks and tight bends glow red through the jacket in patch panels and trays. It works up to a few kilometres and only where you can see the fibre.
Use an OTDR for longer links
The OTDR sends pulses and measures the light reflected back. The trace shows each connector, splice and break as an event with its distance and loss. Use a launch fibre so the first connector is visible.
Read the trace
A sudden large drop and no signal after it means a break. A step drop without reflection is a splice or bend. A reflective spike is a connector. Compare with the trace recorded at installation.
Find the location on site
Convert the OTDR distance to the cable route using the documentation and cable length markings. Remember slack loops in manholes and cabinets.
Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.
Pro tips
- Record OTDR traces of every link at installation as a baseline.
- On GPON, test from the ONU side or use an OTDR with PON filters: splitters hide events beyond them.
- Never look into a fibre, and disconnect active equipment before OTDR testing.
FAQ
Frequently asked questions
Why is my OTDR trace hard to read near the start?
The dead zone after the first strong reflection hides nearby events. A launch fibre of a few hundred metres moves the first connector out of it.
Can I test GPON with a normal OTDR?
Only with care: live PON traffic can disturb it and splitters add large losses. Use a PON-capable OTDR or test with the OLT port disconnected.
Keep learning
Related guides
Clean and inspect fibre connectors
Read more →Measure optical power
Read more →Single-mode vs multimode fibre
Read more →How to Provision ONUs on a GPON OLT
Bring a new subscriber or building online: discover the ONU, authorise it, apply a bandwidth profile and map services to VLANs.
Read more →How to Measure Optical Power and Check a Fibre Link Budget
Use an optical power meter and the device's DDM readings to confirm fibre links are healthy and within budget.
Read more →How to Design a GPON Splitter Plan for a Building
Plan PON ports, splitter ratios and locations for a hotel, tower or campus building, and check that every ONU has enough optical power.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.