Hands-on tutorial

Tutorials · Fibre & GPON

How to Clean and Inspect Fibre Connectors

Dirty connectors cause most fibre faults. Inspect, clean and re-inspect every connector before you connect it, using a scope and the right cleaning tools.

Beginner7 min6 steps

Before you start

  • A fibre inspection scope (or a video probe)
  • One-click cleaners for LC and SC, and lint-free cleaning cards
  • Dust caps

Step by step

  1. Never look into a fibre

    Laser light from a live fibre can damage your eyes even when you cannot see it. Use a scope, never your eye, and disconnect the active end if possible.

  2. Inspect first

    Look at the connector end face with the scope. Dust, oil and scratches show up as dark spots or lines. Inspect both the patch cord and the port or adapter.

  3. Clean dry

    Use a one-click cleaner or a fresh area of a cleaning card. Push once, straight, in one direction. Do not reuse the same area of a card.

  4. Re-inspect

    If spots remain, clean again. For oily dirt, use a solvent made for fibre, then a dry clean.

  5. Clean the port too

    Use the one-click cleaner in the adapter or transceiver port. A clean cord in a dirty port becomes dirty again.

  6. Connect and measure

    Connect immediately and check the optical level on the switch or with a power meter.

    show interfaces transceiver detail
    

Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.

Pro tips

  • Put dust caps back on every unused connector and port.
  • Keep cleaning tools in every technician bag and every cabinet.
  • Never touch the end face with your fingers.