Hands-on tutorial
Tutorials · Fibre & GPON
How to Design a GPON Splitter Plan for a Building
Plan PON ports, splitter ratios and locations for a hotel, tower or campus building, and check that every ONU has enough optical power.
Before you start
- Floor plans with the number of endpoints per floor or room
- The OLT datasheet: PON ports, maximum split and reach
- The optical budget class of the OLT and ONU optics
Step by step
Count the endpoints
List every endpoint that needs an ONU: apartments, hotel rooms, offices, corridor cameras and access points. Add 10–20% for growth.
Choose the split ratio
Common designs use 1:32 or 1:64 per PON port. A lower split gives each user more bandwidth and more optical margin; a higher split uses fewer OLT ports. Stay within the maximum split on the OLT datasheet.
Choose one- or two-stage splitting
Single stage: one large splitter per PON port in the main comms room. Two stage: a 1:4 or 1:8 splitter in the riser and 1:8 splitters on each floor. Two-stage designs need less fibre in the riser.
Calculate PON ports
Divide the endpoints by the split ratio and round up. For example, 400 apartments at 1:32 need 13 PON ports.
PON ports = ceiling(endpoints / split ratio)Check the optical budget
Add the losses: about 17 dB for a 1:32 splitter, 0.35 dB per km of fibre at 1310 nm, 0.3 dB per connector and 0.1 dB per splice. The total must stay inside the budget of the optics, with at least 3 dB margin.
Choose ONU types
Wi-Fi ONUs for apartments and rooms, PoE ONUs for cameras and access points in corridors, and ONUs with voice ports where analogue phones remain.
Document and label
Label every splitter port and record which ONU serial is behind it. This makes provisioning and troubleshooting much faster.
Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.
Pro tips
- Leave spare PON ports on the OLT and spare outputs on splitters.
- Keep splitters in accessible, ventilated cabinets, not above ceilings.
- Measure optical power at a few ONUs after installation and record the values.
FAQ
Frequently asked questions
Does every user on a PON port share the bandwidth?
Yes. A GPON port carries 2.5 Gbit/s down and 1.25 Gbit/s up, shared by all ONUs on it. XGS-PON raises this to 10 Gbit/s in both directions.
Can I mix GPON and XGS-PON?
On combo OLT ports, yes: both run on the same fibre at different wavelengths, so you can upgrade users gradually.
Keep learning
Related guides
GPON vs XGS-PON vs EPON
Read more →Provision ONUs on a GPON OLT
Read more →Measure optical power and check the link budget
Read more →How to Provision ONUs on a GPON OLT
Bring a new subscriber or building online: discover the ONU, authorise it, apply a bandwidth profile and map services to VLANs.
Read more →How to Measure Optical Power and Check a Fibre Link Budget
Use an optical power meter and the device's DDM readings to confirm fibre links are healthy and within budget.
Read more →How to Choose SFP Transceivers and Fibre Patch Cords That Work Together
Pick the right SFP, SFP+, SFP28 or QSFP module, the right fibre type and the right connectors, so uplinks come up the first time.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.