Hands-on tutorial

Tutorials · PoE

How to Use PoE-Powered Switches and PoE Pass-Through in Ceilings and Classrooms

Add ports where there is no power outlet: a small switch powered by PoE from upstream can feed a few devices, and pass some of that power on to them.

Beginner7 min6 steps

Before you start

  • A PoE++ (802.3bt) or PoE+ upstream switch port
  • A PoE-powered (PD) switch with pass-through
  • The power needed by each downstream device

Step by step

  1. Understand the power maths

    The small switch receives power from upstream, uses some itself, and passes the rest to its ports. With 60 W (802.3bt type 3) at the input, roughly 40–45 W may be left for downstream devices, depending on the model.

  2. Use bt upstream for more power

    An 802.3bt upstream port gives far more pass-through power than PoE+. Check the switch's pass-through budget for each input type.

  3. Count the downstream devices

    A PoE-powered switch suits a few phones, a camera or an access point; not a full row of high-power devices.

  4. Mind the bandwidth

    All downstream devices share one uplink cable back to the main switch. That is fine for phones and cameras, and limiting for several Wi-Fi 7 access points.

  5. Install and label

    Mount the switch safely in the ceiling or furniture, and label it in the documentation; small switches in ceilings are easily forgotten.

  6. Check power on the main switch

    Confirm the upstream port negotiates the expected class and that the main switch's budget covers it.

    show poe interface gi1/0/24
    

Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.

Pro tips

  • Avoid chaining many PoE-powered switches; each step loses power.
  • Use managed models so loops and VLANs are under control.
  • Keep the upstream cable within 100 m.