Hands-on tutorial
Tutorials · Fibre & GPON
How to Choose SFP Transceivers and Fibre Patch Cords That Work Together
Pick the right SFP, SFP+, SFP28 or QSFP module, the right fibre type and the right connectors, so uplinks come up the first time.
Before you start
- The port types on both switches (SFP, SFP+, SFP28, QSFP28)
- The distance between the switches
- Whether existing fibre is single-mode or multimode
Step by step
Match the port and the speed
SFP is 1G, SFP+ 10G, SFP28 25G, QSFP+ 40G and QSFP28 100G. Many SFP+ ports also accept 1G SFPs. Both ends of a link must run the same speed.
Match the fibre type
Multimode (OM3/OM4, usually aqua) suits short runs inside a building, up to about 300–400 m at 10G. Single-mode (OS2, usually yellow) covers kilometres and is the default for new installations.
Match the wavelength and reach
Use the same module type at both ends: for example 10GBASE-SR for multimode, 10GBASE-LR (1310 nm, 10 km) for single-mode. BiDi modules use one fibre and must be ordered as a matched pair (for example 1270/1330 nm).
Match the connectors
Most SFP modules use duplex LC. Check the patch panel: SC or LC, UPC or APC. Never connect an APC (green) connector to a UPC (blue) one.
Use short copper or DAC for very short links
Inside one rack, direct-attach copper (DAC) cables are cheaper and use less power than two optics and a patch cord.
Install and verify
Insert the module, connect the patch cord (transmit to receive), and read the module information and optical levels on the switch.
show interfaces transceiver show interfaces te1/0/1 status
Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.
Pro tips
- Keep dust caps on unused modules and cords.
- Order one spare module of each type per site.
- Record module type and serial in your network documentation.
FAQ
Frequently asked questions
The link does not come up. What do I check first?
Swap the two fibres at one end (transmit and receive are crossed), then check that both modules are the same type and speed.
Can I use any brand of SFP?
Use modules approved for the switch. Unsupported modules may not be recognised or may run outside their power specification.
Keep learning
Related guides
Clean and inspect fibre connectors
Read more →Measure optical power
Read more →Link aggregation (LACP)
Read more →How to Provision ONUs on a GPON OLT
Bring a new subscriber or building online: discover the ONU, authorise it, apply a bandwidth profile and map services to VLANs.
Read more →How to Measure Optical Power and Check a Fibre Link Budget
Use an optical power meter and the device's DDM readings to confirm fibre links are healthy and within budget.
Read more →How to Design a GPON Splitter Plan for a Building
Plan PON ports, splitter ratios and locations for a hotel, tower or campus building, and check that every ONU has enough optical power.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.