Hands-on tutorial
Tutorials · Switching
How to Build an Out-of-Band Management Network
Keep access to switches, gateways and servers when the main network is down: a separate management network, console servers, 4G backup access and strict security.
Before you start
- A list of critical devices with management or console ports
- A small management switch per rack or site
- A secure remote access method for the management network
Step by step
Separate management from production
Connect dedicated management ports (or a management VLAN on separate hardware) to a management switch that does not depend on the production core.
Add console servers
A console server connects to the serial console of each critical device, so you can recover even if the device has no network configuration.
Give it its own path
Connect the management network to the outside through a separate internet link or a 4G/5G router, so you can reach it during a full outage.
Secure access tightly
Access only through VPN with MFA, from named administrator accounts, with logging. Never expose console servers to the internet.
Power it independently
Put the management switch, console server and 4G router on UPS power.
Test it
Disconnect the production uplink in a maintenance window and confirm you can still reach every critical device.
Pro tips
- Label console cables and ports clearly.
- Keep management IP plans separate from production.
- Use the management network for backups and monitoring traffic too.
FAQ
Frequently asked questions
Is a management VLAN enough?
It helps, but if the production switches fail, the VLAN fails with them. True out-of-band management uses separate hardware and paths.
Do small sites need this?
A 4G router plus remote access to the gateway's management interface is often enough for small sites.
Keep learning
Related guides
Secure switch and router management
Read more →SSH jump host
Read more →5G or 4G backup internet
Read more →How to Configure VLANs on a Managed Switch
Separate staff, guests, voice and cameras into their own VLANs: create VLANs, set access and trunk ports, and verify traffic separation.
Read more →How to Set Up Inter-VLAN Routing on a Layer 3 Switch
Route between VLANs at wire speed using switch virtual interfaces (SVIs), a DHCP relay and ACLs that control which networks can talk.
Read more →How to Configure Link Aggregation (LACP) Between Switches
Bundle two or more links into one logical link for more bandwidth and redundancy using IEEE 802.3ad LACP.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.