Hands-on tutorial
Tutorials · Video Surveillance
How to Set Up a Number Plate Recognition (LPR/ANPR) Camera
Place, aim and tune a licence plate recognition camera at a gate or car park so plates are read reliably by day and night.
Before you start
- An LPR/ANPR camera or a camera with plate recognition
- The lane width, vehicle speed and gate position
- A recorder or software that stores plate events, and a list of allowed plates if you control a barrier
Step by step
Choose the capture point
Pick a point where vehicles slow down or stop, such as before a barrier. One camera per lane gives the best results.
Mind the angles
Keep the horizontal angle to the plate below about 30° and the vertical angle below about 30°. Mount at 1–2 m height for gates, higher for car parks with care.
Get enough pixels on the plate
Plates need roughly 130–250 pixels across, depending on the software. Use the camera's zoom lens to frame the lane, not the whole scene.
Use a fast shutter
Set a shutter of 1/1000 s or faster for moving vehicles, so plates are not blurred. Use the camera's infrared, which plates reflect strongly at night.
Define the detection area
Draw the detection region over the lane only, to avoid reading parked cars or reflections.
Connect to the gate system
Add allowed plates to the list and connect the camera's alarm output or network event to the barrier controller. Test with real vehicles.
Review the accuracy
Check plate events for a week, especially at night and in rain, and adjust angle, zoom and shutter until misses are rare.
Pro tips
- Avoid pointing the camera into headlights or the low sun.
- Keep plate data under your data protection policy with a defined retention period.
- Keep an overview camera alongside the LPR camera for context.
FAQ
Frequently asked questions
Can a normal CCTV camera read plates?
Sometimes by day, rarely by night. Dedicated LPR settings, zoom and infrared make it reliable.
How fast can vehicles go?
It depends on the camera and settings; for gates, vehicles are slow. For roads, choose cameras rated for the speed.
Keep learning
Related guides
Camera placement and DORI
Read more →AI smart events on IP cameras
Read more →Set up IP cameras with a PoE switch and NVR
Read more →How to Set Up IP Cameras With a PoE Switch and NVR
From unboxing to recording: plan IP addresses, power cameras with PoE, add them to the NVR and set recording and retention.
Read more →How to Access CCTV Remotely Without Port Forwarding
Port-forwarding an NVR to the Internet invites attacks. Use a VPN instead and keep cameras invisible from outside.
Read more →How to Configure NVR Storage, RAID and Retention
Install surveillance drives, choose RAID, set recording quotas and confirm you keep footage for the required number of days.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.