Hands-on tutorial
Tutorials · PoE
How to Choose the Right PoE Standard (802.3af, 802.3at or 802.3bt) for Each Device
Match every IP camera, access point and phone to the right PoE class, check the switch port and the total budget, and avoid devices that reboot or never power up.
Before you start
- The datasheet of each powered device (look for 'power consumption' or 'PoE class')
- The datasheet of the PoE switch: PoE standard per port and total PoE budget
- A list of devices per switch
Step by step
Read the device's maximum power
Take the maximum, not the typical figure. Cameras draw most at night with infrared on, and outdoor cameras with heaters draw much more in winter. Wi-Fi 7 access points draw most with all radios busy.
Map the power to a PoE standard
802.3af (PoE) delivers up to 15.4 W at the switch port, about 12.95 W at the device. 802.3at (PoE+) delivers 30 W, about 25.5 W at the device. 802.3bt (PoE++) delivers 60 W (type 3) or 90 W (type 4) at the port. Pick the lowest standard that covers the device's maximum.
Check each switch port
A switch may offer PoE+ on every port but 802.3bt only on a few. Put high-power devices such as PTZ cameras with heaters or multi-radio access points on the bt-capable ports.
Check the total budget
Add the maximum power of every device on the switch and add 20–30% headroom. The total must stay below the switch's PoE budget, or the switch will refuse or drop power to some ports.
show poe status show poe power-budget
Check the cable
Use Cat5e or better, at most 100 m. Long runs of thin or copper-clad aluminium cable lose power as heat and are the most common cause of devices that reboot under load.
Verify under load
Power everything on, switch camera infrared on (cover the lens or test at night), and read the per-port power on the switch. Each port should stay below its class limit.
Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.
Pro tips
- Label high-power ports on the switch and in your documentation.
- Leave a few spare PoE ports and budget for future cameras.
- Use the PoE watchdog or scheduled reboot for cameras that occasionally freeze.
FAQ
Frequently asked questions
Can a PoE+ switch power an 802.3af camera?
Yes. PoE is backward compatible: a PoE+ port negotiates the lower class the camera asks for.
Is passive 24 V PoE the same as 802.3af?
No. Passive PoE has no negotiation and can damage standard devices. Use only standard 802.3af/at/bt switches and injectors with standard devices.
Keep learning
Related guides
PoE power budget with worked examples
Read more →Troubleshoot PoE devices that won't power up
Read more →PoE vs PoE+ vs PoE++
Read more →How to Use PoE Scheduling and Remote Power-Cycling
Save energy by switching PoE off outside business hours, and reboot a frozen camera or access point remotely.
Read more →How to Troubleshoot PoE Devices That Won't Power Up or Keep Rebooting
A systematic checklist for cameras and access points that stay dark, flicker or reboot at night.
Read more →How to Power Remote Cameras Beyond 100 m With Long-Range PoE, Extenders or Fibre
Reach gates, car parks and perimeter fences that are more than 100 m from the switch: compare long-range PoE, inline extenders and fibre with a local PoE switch, and pick the right one.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.