Hands-on tutorial
Tutorials · PoE
How to Power Remote Cameras Beyond 100 m With Long-Range PoE, Extenders or Fibre
Reach gates, car parks and perimeter fences that are more than 100 m from the switch: compare long-range PoE, inline extenders and fibre with a local PoE switch, and pick the right one.
Before you start
- The cable distance from the switch to each remote device
- The power and bandwidth of each device
- Whether a power outlet exists at the remote location
Step by step
Measure the real cable route
Measure along the route the cable will take, not in a straight line. Add slack for the cabinet and the pole.
Up to about 250 m: long-range PoE
Some switches have a long-range or extend mode that lowers the link speed to 10 Mbit/s so a single Cat6 run can reach about 250 m. 10 Mbit/s is enough for one 2–4 MP camera, not for an access point.
interface gi1/0/8 poe extend-mode enable
Up to a few hundred metres: PoE extenders
An inline extender regenerates Ethernet and passes PoE on, adding up to 100 m per extender. Each extender consumes some power, so check the budget at the switch port.
Beyond that, or between buildings: fibre
Run single-mode fibre to a small outdoor PoE switch in a cabinet with its own power supply. This also isolates the main network from lightning on long outdoor copper runs.
Protect outdoor runs
Add surge protectors at both ends of outdoor copper, earth the cabinet, and use outdoor-rated, UV-resistant cable.
Test the link
Check link speed and errors on the switch port, and watch the camera stream at night with infrared on, when power and bandwidth are highest.
show interfaces gi1/0/8 status show interfaces gi1/0/8 counters errors
Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.
Pro tips
- Never exceed the PoE class at the far end: extenders and long cables both lose power.
- For several remote cameras in one place, one fibre and a small switch is cheaper than many long copper runs.
FAQ
Frequently asked questions
Why does long-range mode drop to 10 Mbit/s?
Lower speeds are more tolerant of signal loss on long cables, which is what makes the extra distance possible.
Can I use a wireless bridge instead?
Yes, for line-of-sight links. Power the remote end locally and size the bridge for the total camera bandwidth.
Keep learning
Related guides
Plan a wireless bridge
Read more →Build an outdoor industrial cabinet
Read more →Choose the right PoE standard
Read more →How to Use PoE Scheduling and Remote Power-Cycling
Save energy by switching PoE off outside business hours, and reboot a frozen camera or access point remotely.
Read more →How to Troubleshoot PoE Devices That Won't Power Up or Keep Rebooting
A systematic checklist for cameras and access points that stay dark, flicker or reboot at night.
Read more →How to Choose the Right PoE Standard (802.3af, 802.3at or 802.3bt) for Each Device
Match every IP camera, access point and phone to the right PoE class, check the switch port and the total budget, and avoid devices that reboot or never power up.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.