Hands-on tutorial
Tutorials · Wi-Fi
How to Troubleshoot Slow Wi-Fi Step by Step
Find out whether slow Wi-Fi is caused by signal, interference, too many clients, the access point uplink or the internet, and fix the real cause instead of rebooting.
Before you start
- A laptop or phone with a Wi-Fi analyser app
- Access to the access point or controller dashboard
- A speed test or iperf3 server on the local network
Step by step
Separate Wi-Fi from the internet
Run a speed test on a wired laptop next to the access point. If wired is also slow, the problem is the internet link or the gateway, not Wi-Fi.
Check the signal where users complain
Stand where users sit and read the signal strength (RSSI). Around −65 dBm or better is good; below −72 dBm, speed drops quickly. Weak signal means a missing access point or one in the wrong place.
Check which band and access point the device uses
Devices stuck on 2.4 GHz or on a distant access point are slow. Enable band steering and 802.11k/v roaming help, and lower transmit power on access points that reach too far.
Look for interference and channel overlap
On 2.4 GHz use only channels 1, 6 and 11 at 20 MHz. On 5 GHz, make sure neighbouring access points use different channels. A Wi-Fi analyser shows overlapping networks.
Count clients and airtime
Check the dashboard for clients per access point and channel utilisation. Above about 60–70% utilisation, everyone slows down. Add access points or move busy areas to 5 and 6 GHz.
Check the access point uplink
A Wi-Fi 6 or Wi-Fi 7 access point on a 100 Mbit/s or error-prone switch port cannot deliver its speed. Check the port speed and errors.
show interfaces gi1/0/12 status show interfaces gi1/0/12 counters errors
Test from the client to the LAN
Run iperf3 from a Wi-Fi client to a wired server to measure pure Wi-Fi throughput, independent of the internet.
iperf3 -c 192.168.10.20 -t 20 iperf3 -c 192.168.10.20 -t 20 -R
Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.
Pro tips
- Old devices on Wi-Fi 4 slow down the whole cell; a separate SSID or band for them helps.
- Disable the lowest data rates (1, 2, 5.5 Mbit/s) to stop clients clinging to distant access points.
- Write down what you changed and re-test, one change at a time.
FAQ
Frequently asked questions
Why is Wi-Fi fast near the access point but slow in the next room?
Walls, glass and metal reduce the signal. The device then uses lower data rates. The fix is usually another access point, not more power.
Will a firmware update fix slow Wi-Fi?
Sometimes, especially with roaming bugs, but most slow Wi-Fi is caused by placement, channels or overload.
Keep learning
Related guides
Wi-Fi channel planning
Read more →Why is my network slow? Checklist
Read more →How many access points do I need?
Read more →How to Set Up Secure Guest Wi-Fi With Client Isolation
Give visitors Internet access without exposing your internal network: separate SSID and VLAN, client isolation, bandwidth limits and an optional captive portal.
Read more →How to Plan Wi-Fi Channels on 2.4, 5 and 6 GHz
Reduce interference and increase capacity by choosing the right channels and widths for each band.
Read more →How to Secure Wi-Fi With WPA3-Enterprise and RADIUS
Replace shared Wi-Fi passwords with per-user authentication using 802.1X, a RADIUS server and WPA3-Enterprise (or WPA2-Enterprise for older devices).
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.