Hands-on tutorial
Tutorials · Wi-Fi
How to Add 6 GHz (Wi-Fi 6E and Wi-Fi 7) to an Existing Wi-Fi Network
Plan the move to 6 GHz: check which devices support it, adapt security to WPA3, adjust access point placement and channel widths, and keep older devices working.
Before you start
- A list of client devices and their Wi-Fi generation
- Access points that support 6 GHz
- The 6 GHz rules for your country (allowed channels and power)
Step by step
Check your country's rules
6 GHz availability and power limits differ by country. Some allow the full band, others the lower part, and some none yet. Configure the access points for the correct country.
Check client support
Only Wi-Fi 6E and Wi-Fi 7 devices use 6 GHz. Most networks keep 2.4 and 5 GHz for older devices for years.
Use WPA3
6 GHz requires WPA3 (or OWE for open networks). Create the 6 GHz SSID with WPA3, or a WPA3 transition SSID on all bands if older devices share it.
Check coverage
6 GHz travels a little less through walls than 5 GHz. Run a survey or predictive design; you may need slightly more access points.
Choose channel widths
6 GHz has room for many 80 MHz channels and 160 or 320 MHz channels in quiet areas. In dense offices, 80 MHz gives more parallel channels.
Upgrade the wired side
Wi-Fi 6E and Wi-Fi 7 access points need multi-gigabit PoE+ switch ports to deliver their speed.
Pro tips
- Advertise 6 GHz through the 5 GHz radio (reduced neighbour reports) so clients discover it quickly.
- Keep the same SSID name across bands with care: WPA3-only on 6 GHz can confuse older devices on mixed SSIDs.
- Test video calls and roaming after the change.
FAQ
Frequently asked questions
Do I need new access points for 6 GHz?
Yes. 6 GHz needs a radio that supports it: Wi-Fi 6E or Wi-Fi 7 access points.
Is 6 GHz faster?
It offers wide, clean channels with no legacy devices, so throughput and latency are usually much better where coverage is good.
Keep learning
Related guides
Wi-Fi 7 MLO explained
Read more →Wi-Fi channel planning
Read more →WPA3-Enterprise with RADIUS
Read more →How to Set Up Secure Guest Wi-Fi With Client Isolation
Give visitors Internet access without exposing your internal network: separate SSID and VLAN, client isolation, bandwidth limits and an optional captive portal.
Read more →How to Plan Wi-Fi Channels on 2.4, 5 and 6 GHz
Reduce interference and increase capacity by choosing the right channels and widths for each band.
Read more →How to Secure Wi-Fi With WPA3-Enterprise and RADIUS
Replace shared Wi-Fi passwords with per-user authentication using 802.1X, a RADIUS server and WPA3-Enterprise (or WPA2-Enterprise for older devices).
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.