Hands-on tutorial
Tutorials · Wi-Fi
How to Deploy In-Room Wall-Plate Access Points in Hotels and Dormitories
Put an access point in every room: when in-room wall-plate APs beat corridor APs, power and channel planning, wired ports for TVs and phones, and VLANs per service.
Before you start
- Room layouts and wall construction
- An existing Ethernet outlet per room (or plans to add one)
- PoE switches on each floor
Step by step
Decide corridor or in-room
Corridor access points struggle through concrete walls and bathrooms. In-room access points give each room its own strong signal and capacity, which guests notice.
Use the existing outlet
Wall-plate access points replace a standard Ethernet outlet and are powered by PoE. Many also have extra Ethernet ports for the TV, phone or minibar.
Lower the power
With an access point in every room, set transmit power low and use 20 MHz on 2.4 GHz and 20–40 MHz on 5 GHz so neighbouring rooms do not interfere.
Plan channels
Alternate channels between adjacent rooms and floors. Automatic channel planning helps, but review it after installation.
Map ports to VLANs
Wi-Fi guests on the guest VLAN, the TV port on the IPTV VLAN, the phone port on the voice VLAN, each isolated.
Manage centrally
Hundreds of access points need central management, firmware updates and alerts, for example in NavCloud.
Test from the bed and the bathroom
Measure signal and speed where guests actually use their devices.
Pro tips
- Keep a few spare wall-plate units for quick swaps.
- Lock the access point to the wall to prevent theft.
- Check that the PoE budget covers access points plus phones on the same switch.
FAQ
Frequently asked questions
Is one access point per room too many?
Not with low power and good channel planning; it gives the most consistent experience in hotels with thick walls.
Can guests plug devices into the extra ports?
Only if you want them to; map the guest-facing port to the guest VLAN or disable it.
Keep learning
Related guides
Hotel Wi-Fi design checklist
Read more →Hotel IPTV networks
Read more →Wi-Fi channel planning
Read more →How to Set Up Secure Guest Wi-Fi With Client Isolation
Give visitors Internet access without exposing your internal network: separate SSID and VLAN, client isolation, bandwidth limits and an optional captive portal.
Read more →How to Plan Wi-Fi Channels on 2.4, 5 and 6 GHz
Reduce interference and increase capacity by choosing the right channels and widths for each band.
Read more →How to Secure Wi-Fi With WPA3-Enterprise and RADIUS
Replace shared Wi-Fi passwords with per-user authentication using 802.1X, a RADIUS server and WPA3-Enterprise (or WPA2-Enterprise for older devices).
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.