Hands-on tutorial
Tutorials · Video Surveillance
How to Design a CCTV Control Room and Video Wall
Plan a control room operators can work in: number of screens, layouts, decoders, network and recording, and ergonomics for long shifts.
Before you start
- The number of cameras and which must be watched live
- The number of operators per shift
- The video management software and its decoding requirements
Step by step
Decide what is watched live
Operators cannot watch hundreds of cameras. Show critical cameras live, and use alarms and smart events to bring others to the screen.
Size the wall
Plan screens by layout: for example a 3 × 3 wall of 55-inch displays, each showing 4 to 9 cameras. Use the sub-stream for small tiles and the main stream for full-screen.
Choose decoding
Use a video wall controller, decoders or workstations with enough GPU decoding capacity for all tiles at once. Check the vendor's figures for H.265 at your resolutions.
Plan the network
Live viewing adds traffic from the NVRs or cameras to the control room. Calculate the streams and use multicast with IGMP snooping where supported.
Design the workplace
Operators should see the wall without turning their heads too far. Use 2–3 monitors per desk, adjustable chairs and controlled lighting to avoid glare.
Plan resilience
Put screens, controllers and network on UPS power, and keep a second workstation able to run the wall.
Write procedures
Define what operators do on each alarm type, how incidents are recorded and how footage is exported for evidence.
Pro tips
- Group cameras on the wall by location, not by camera number.
- Rotate operator tasks to keep attention high.
- Restrict USB ports and exports on operator workstations.
FAQ
Frequently asked questions
How many cameras can one operator watch?
Attention drops quickly with many live images. Use fewer live tiles and rely on analytics and alarms for the rest.
Do I need a dedicated video wall controller?
For large walls, yes. Small walls can run from a powerful workstation with several outputs.
Keep learning
Related guides
IGMP snooping for multicast
Read more →Calculate NVR storage and bandwidth
Read more →AI smart events on IP cameras
Read more →How to Set Up IP Cameras With a PoE Switch and NVR
From unboxing to recording: plan IP addresses, power cameras with PoE, add them to the NVR and set recording and retention.
Read more →How to Access CCTV Remotely Without Port Forwarding
Port-forwarding an NVR to the Internet invites attacks. Use a VPN instead and keep cameras invisible from outside.
Read more →How to Configure NVR Storage, RAID and Retention
Install surveillance drives, choose RAID, set recording quotas and confirm you keep footage for the required number of days.
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.