Tutorials · Wi-Fi
How to Install and Align a Point-to-Point Wireless Bridge
Mount, align and secure a 5.8 GHz bridge between two buildings for a stable high-speed link.
Before you start
- A pair of wireless bridges and mounting kits
- Clear line of sight between sites
- PoE injectors or PoE switch ports
Step by step
Survey the path
Confirm line of sight and Fresnel-zone clearance; plan mounting heights.
Pre-configure on the bench
Set one unit as access point (master) and the other as station (client), with the same SSID, channel and strong WPA2/WPA3 key. Change default admin passwords.
Mount rigidly
Use the mast kit and tighten fully; movement of a few degrees ruins long links.
Align
Turn one end slowly while watching the signal indicator or RSSI page, then fine-tune the other end.
Choose the channel
Run a spectrum scan and pick the cleanest channel.
Test and document
Measure throughput both ways and save signal levels and configurations.
Pro tips
- Ground masts and use outdoor-rated, shielded cable with surge protection.
- Disable unused management services on the bridges.
FAQ
Frequently asked questions
How far can the link reach?
It depends on the model and line of sight. Navijin bridges are specified for up to 3–4 km.
Keep learning
Related guides
Wireless bridge planning
Read more →Wireless bridge solution
Read more →How to Set Up Secure Guest Wi-Fi With Client Isolation
Give visitors Internet access without exposing your internal network: separate SSID and VLAN, client isolation, bandwidth limits and an optional captive portal.
Read more →How to Plan Wi-Fi Channels on 2.4, 5 and 6 GHz
Reduce interference and increase capacity by choosing the right channels and widths for each band.
Read more →How to Secure Wi-Fi With WPA3-Enterprise and RADIUS
Replace shared Wi-Fi passwords with per-user authentication using 802.1X, a RADIUS server and WPA3-Enterprise (or WPA2-Enterprise for older devices).
Read more →Stuck on a step?
Ask Navijin technical support or an authorised partner for help with your configuration.