3 November 2026

CCTV Network Design: How to Calculate Bandwidth and Storage for IP Cameras

Most CCTV problems that appear after installation, such as choppy video, missing recordings or a full NVR after two weeks, come from the same mistake: the network and storage were not sized for the cameras. This guide shows a simple method you can use before you buy switches and hard drives.

Step 1: Estimate the bitrate of each camera

Bitrate depends on resolution, frame rate, codec and scene activity. These are typical values for H.265 at 25 fps with normal activity; busy scenes and night-time noise can double them.

ResolutionH.264 (typical)H.265 (typical)
2 MP (1080p)4 Mbps2 Mbps
4 MP6–8 Mbps3–4 Mbps
5 MP8–10 Mbps4–5 Mbps
8 MP (4K)12–16 Mbps6–8 Mbps

Add about 10% for the sub-stream used for live view on phones and the NVR grid.

Step 2: Size the switch

  • Uplink: add up all camera bitrates on the switch and keep the total below 60–70% of the uplink speed. Twenty-four 4 MP H.265 cameras at 4 Mbps = 96 Mbps, comfortable on a 1G uplink. For 48 cameras or 4K cameras, use 10G SFP+ uplinks.
  • PoE budget: fixed cameras usually need 5–8 W, cameras with IR or heaters 10–15 W, and PTZ cameras 25–60 W. Add 20–30% headroom. A 16-port switch with a 250 W budget, such as the Navijin GE1610-2SF, comfortably powers 16 fixed cameras.
  • Distance: copper Ethernet is limited to 100 m. For longer runs use fiber SFP uplinks or an extended-distance PoE mode.

Step 3: Calculate storage

Use this formula:

Storage (GB) = bitrate (Mbps) × 10.8 × days × number of cameras

One camera streaming 1 Mbps for 24 hours writes about 10.8 GB. Divide by 1,000 to get TB.

ExampleResult
16 × 4 MP cameras, H.265 at 4 Mbps, 24/7, 30 days4 × 10.8 GB × 30 × 16 ≈ 20.7 TB
Same with motion recording (≈40% of the time)≈ 8.3 TB
32 × 2 MP cameras, H.265 at 2 Mbps, 24/7, 30 days2 × 10.8 GB × 30 × 32 ≈ 20.7 TB

Always add 10–15% free space, and use RAID or a redundant NVR for sites where recordings are evidence.

Step 4: Separate the CCTV network

  • Put cameras in their own VLAN and block internet access from that VLAN.
  • Change default passwords and disable unused services on every camera.
  • Use managed switches with port security so an unknown device cannot be plugged into a camera port.

Quick checklist

  • Camera count, resolution and codec listed
  • Total bitrate per switch below 70% of the uplink
  • PoE budget with 20–30% headroom
  • Storage sized for the retention period plus 15%
  • Cameras on a separate VLAN

Navijin supplies IP cameras, NVRs, PoE switches and SFP modules from one brand, with local stock in Dubai, Baku and Tripoli. Send us your camera list and we will size the switches and storage for free: request a quotation or explore our video surveillance solution.