Hands-on tutorial

Tutorials · Video Surveillance

How to Calculate NVR Storage and Bandwidth for IP Cameras

Work out bitrate per camera, total recording bandwidth, disk capacity for the retention you need, and the uplink bandwidth for live viewing.

Intermediate11 min6 steps

Before you start

  • Camera resolution, frame rate and codec (H.264, H.265 or H.265+)
  • Recording mode: continuous, motion or schedule
  • The required retention in days

Step by step

  1. Estimate the bitrate per camera

    Use the camera's bitrate setting or typical values: a 4 MP camera at 25 fps uses roughly 4–6 Mbit/s in H.265, and 2–3 Mbit/s with smart codecs on quiet scenes. Busy scenes and night noise raise the bitrate.

  2. Add up the recording bandwidth

    Multiply the bitrate by the number of cameras. The NVR's incoming bandwidth (on its datasheet) must be higher than this total.

    total Mbit/s = cameras × bitrate
    
  3. Calculate storage per day

    One Mbit/s recorded for 24 hours is about 10.8 GB. Multiply by the total bitrate and by the share of time recorded (100% continuous, often 30–50% with motion recording).

    GB per day = total Mbit/s × 10.8 × recording share
    
  4. Multiply by retention

    Multiply by the retention days and add 10–15% for file system overhead. Choose disks with that capacity, plus RAID if the NVR supports it.

    TB needed = GB per day × days × 1.15 / 1000
    
  5. Check the network

    Each camera's stream crosses its access switch and the uplink to the NVR. Remote viewing uses the sub-stream, which is much smaller. Put cameras in their own VLAN.

  6. Validate after installation

    After a week, compare the real disk use per day with your estimate and adjust bitrate, frame rate or retention.

Commands are generic, industry-standard examples. Exact syntax and menu names vary by model and firmware; check your device's manual on the Documentation page.

Pro tips

  • Use surveillance-rated hard disks, not desktop disks.
  • Record the main stream, view remotely with the sub-stream.
  • Check local law: some sectors require a minimum retention period.

FAQ

Frequently asked questions

Example: 16 cameras at 4 Mbit/s, continuous, 30 days?

16 × 4 = 64 Mbit/s. 64 × 10.8 ≈ 691 GB per day. 691 × 30 × 1.15 ≈ 23.8 TB. Three 10 TB disks in RAID 5 give about 20 TB usable, so plan four disks.

Does H.265 really halve the storage?

Often close to that compared with H.264 at the same quality, more on static scenes and less on busy ones.

Stuck on a step?

Ask Navijin technical support or an authorised partner for help with your configuration.